Call now
Call now
Boiler installation, replacement and central heating in Keynsham, from a Gas Safe registered engineer based in Staple Hill.
Almost all of Julian's work comes from repeat customers and recommendations. Over forty years, that is the only measure that means anything.
Keynsham sits south of our base in Staple Hill, down through Kingswood and Hanham. Julian has been fitting and repairing central heating across this side of Bristol for over forty years.
He is Gas Safe registered, reg. 198984, and a Worcester Bosch accredited installer, so a new Greenstar boiler carries up to a 12-year manufacturer guarantee. He also holds the unvented hot water and LPG qualifications.
Keynsham has a real spread of housing. Georgian and Victorian properties along the High Street and the older streets near the abbey, large postwar estates built out towards Chandag and Queens Road, and newer development on the former Cadbury’s factory site.
The older stone properties near the centre need proper heat loss calculations rather than a standard radiator chart, because solid walls lose heat far faster than cavity walls. Getting that wrong is the usual reason a room never feels warm no matter how long the heating runs.
A straight swap is usually a single day, so heating and hot water are back the same evening.
In the older stone properties near the centre, new radiators often do more than a new boiler.
Annual servicing keeps your guarantee valid. Landlord CP12 certificates also available.
Boiler replacement makes up most of the work. A straight swap in the same position is usually a single day. Converting from an old cylinder system to a combi takes about two days and clears the airing cupboard and the loft tanks.
A full central heating installation takes four to five days. Every radiator is sized to its room, the system is flushed and dosed with inhibitor, and a magnetic filter is fitted to protect the new boiler and its guarantee.
In the older properties, replacing tired single panel radiators with modern double panel units often does more for comfort than anything else, and costs far less than a whole new system. Julian will say when that is the better spend rather than quoting the bigger job.
Keynsham is towards the southern edge of Julian’s service area, around five miles from base, so it is comfortably in range but worth booking a little ahead.
Landlords can book the annual CP12 certificate. Julian works Monday to Friday 8am to 6pm and weekend mornings, with no emergency or out-of-hours callouts.
Solid stone and brick walls near the High Street and the older streets. These lose heat differently from cavity walls, so the boiler is sized from a proper heat loss calculation rather than a rule of thumb.
Keynsham expanded substantially after the war, and much of the town is conventional cavity wall housing with straightforward pipe runs and predictable heat requirements.
Few areas we cover span such a range of building age. The right answer for a Georgian townhouse is rarely the right answer for a nineteen seventies semi, which is why nothing is quoted before it has been looked at.
Older houses often still carry sections of original pipework, sometimes narrower than modern standards. That gets checked before a new boiler goes on, not after the first cold room appears.
Yes. Keynsham is around five miles south of base, comfortably within the service area, though worth booking a little ahead rather than expecting same-day attendance.
Not at all, but it needs proper heat loss calculations. Solid walls lose heat far faster than cavity walls, and radiators sized from a chart come out too small.
Yes. Swapping old single panel radiators for modern double panel units, then balancing the system, frequently transforms an older house for far less than a full replacement.
A straightforward replacement is usually done in a day. Converting from an old cylinder system to a combi takes about two days.
Most combi boiler replacements start from around £2,000, depending on the boiler and your home. You get a clear, fixed quote before any work begins.
No. Julian works Monday to Friday 8am to 6pm and weekend mornings. If you smell gas, call the National Gas Emergency Service on 0800 111 999.
We also cover Hanham, Warmley, Kingswood, Staple Hill and Mangotsfield. See all the areas we serve.
With Keynsham property ranging from Georgian stone to houses barely a decade old, no single boiler type suits the town. That is why the free survey matters here rather than a price over the phone. Julian is Gas Safe registered under reg. 198984, Worcester Bosch accredited, and qualified for unvented hot water systems where a cylinder turns out to be the right answer.
Keynsham spans about two hundred years of building in a couple of square miles, from Georgian stone near the abbey to houses finished within the last decade. The right heating answer varies enormously across that, which is why the survey matters more here than most places.
Keynsham sits at the southern edge of the patch, so a job here is worth booking a little further ahead than one in Staple Hill. There is no travel charge for the distance. It simply means Julian is fitting it around a day that may already have work at the other end of the area.
Call Julian for a free, no-obligation quote on central heating or a new boiler in Keynsham.